Router Setup Example Forms

Note These are just sample forms. Do not use them to configure your router.

Router ISDN Setup

To configure your router, you have to fill in the fields on this form. Most of the information required should have been supplied by your network manager or service provider.

Router Name and Password

You need to name your router and assign it a password. The router name must be the name that you were told to use. You can choose the password.

Router name

Password

ISDN Interface (BRI0)

You need to know the name of the router that you will be dialing and the password for CHAP authentication on the dialup link. The CHAP password should have been supplied to you; it is different from the router password. You also need to know the type of ISDN switch that the phone company is using, and you might need to know the SPIDs that they have assigned to you. If they are not using SPIDs, you can leave those fields blank.

Remote router name

Remote phone number

Remote CHAP password

ISDN switch type

ISDN Service Profile Identifier (SPID) 1

ISDN Service Profile Identifier (SPID) 2

IP Addresses

The router uses an address of 10.0.0.1. You can change it.

Router IP address

Router netmask

DNS server address

Diagnostic Information

You can enable standard debugging information. Doing so has little or no impact on router performance, but can help diagnose ISDN and dial-on-demand problems. Debugging information is sent to the router console and is stored in an internal buffer.

Please choose one of the options below.

Enable standard debugging
Disable debugging

Router Frame Relay Setup

To configure your router, fill in the following fields. You should have received most of this information from your network manager or service provider.

Router Name and Password

Name your router and give it a password. The router name must be the name that you were told to use. The password is your choice.

Router name
Router password

Frame Relay Setup

Frame Relay IP address
Frame Relay netmask
Frame Relay DLCI

IP Addresses

Router IP address
Router netmask
DNS server IP address

Diagnostic Information

You can enable debugging. This has little or no impact on performance but will help diagnose problems. Debugging information is sent to the console and is stored in an internal buffer.

Please choose one of the options below.

Enable standard debugging
Disable debugging

Router Asynchronous Serial Setup

To configure your router fill in the fields below. Most of the information required should have been supplied to you by your network manager or service provider.

Router Name and Password

Name your router and give it a password. The router name must be the name that you were told to use. The password is your choice.

Router name
Router password

Asynchronous Serial Interface

You need to know the name of the router you will be dialing up, and the password used for CHAP authentication on the link. This CHAP password should have been supplied to you, and is different from the router password above.

Remote router name
Remote phone number
Remote CHAP password

Enter a password to be prompted when a user dials into this router.

Local line password

Select the speed of the modem connected to the router and enter the Modem initialization string.

Modem Speed 14.4k 28.8k
Modem Initialization String IP Addresses Router IP address Router netmask DNS server IP address Diagnostic Information You may want to enable some standard debugging information. This will have little or no impact on performance but will help diagnose WAN and Dial-On-Demand problems. Debugging information is sent to the console and is stored in an internal buffer. Please choose one of the options below. Enable standard debug Disable debug Return to Configure the Router Return to ClickStart Home Page

Table of Contents